Jacuzzi J - 2 0 0 Hot Tub User Manual


 
J-200 Series
Lock Modes (L1-L2)
L1 Lock Out (disables all spa functions to permit lter
cleaning)
L2 Lock Mode (disables the jets and light buttons to
prevent unauthorized use of spa). Filtration/heating
cycle will continue to operate as programmed in
this mode. The temperature display ashes when this function is
enabled. Example: the “F3” ltration/heating cycle was enabled
prior to choosing lock mode. The spa continues to perform the
“F3” cycle until lock mode is canceled, allowing another cycle to be
selected.
To set a time for the rst ltration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. Example: If you desire your
rst ltration/heating cycle to begin at 10:00 AM turn off power to the spa
and turn it back on again at 9:58 AM.
Note: Start time is approximate and may vary slightly from day to day.
11.7 Filtration Modes for Spas With Circulation Pump Option

If your spa is not equipped with the circulation pump option, disregard
this section and refer to page 29forltercycleprogrammingdetails.

(Heater automatically turns on during any heat call while in any Standard
mode).
F0 5 minutes of ltration per day (one 5 minute “Blow-Out”
cycle every 24 hours to purge all plumbing lines)
F1 1 hour of ltration per day (one 30-minute cycle every
twelve hours); this is the factory default setting.
F2 1.5 hours of ltration per day (one 30-minute cycle
every eight hours).
F3 2 hours of ltration per day (one 30-minute cycle every
six hours).

(Heater can only turn on during an active lter cycle while in any
economy mode).
F4 1 hour of ltration/heating per day (one 30-minute
cycle every twelve hours).
F5 1.5 hours of ltration/heating per day (one 30-minute
cycle every eight hours).
F6 2 hours of ltration/heating per day (one 30-minute
cycle every six hours).
30