Filter
Top Products
J-200 Series
Economy ltration/heating modes (F4-F6) are typically selected by
customers in warm climates where heat up times are minimized due
to higher ambient temperatures. In either of these modes, the water
temperature is regulated by the set temperature, low-speed pump or
optional circulation pump, and heater only while a programmed ltration/
heating cycle is running.
Note: These modes can be used to conserve energy while on vacation
or out of town for several weeks since heater operation is minimized.
During such times, you can also minimize the spa set temperature to
maximize energy savings!
11.4 Lock Modes - L1-L2 (All Models)
These modes are designed for use during spa service or to prevent
unauthorized use.
Press and hold both control panel WARMER ( ) and COOLER ( )
buttons at the same time, then release. Then press either WARMER
( ) or COOLER ( ) button to select either ltration/heating mode or
lock mode as outlined below.
11.6 Filtration Modes for Spas Without Circulation Pump Option
(All Models)
If your spa is equipped with the circulation pump option, disregard this
section and refer to page 30forltercycleprogrammingdetails.
(Heater automatically turns on during any heat call while in any Standard
mode).
F1 4 hours of ltration/heating per day (one 2-hour cycle
every 12 hours).
F2 6 hours of ltration/heating per day (one 2-hour cycle
every 8 hours).
F3 8 hours of ltration/heating per day (one 2-hour cycle
every 6 hours)
(Heater can only turn on during an active lter cycle while in any
economy mode).
F4 4 hours of ltration/heating per day (one 2-hour cycle
every 12 hours).
F5 6 hours of ltration/heating per day (one 2-hour cycle
every 8 hours).
F6 8 hours of ltration/heating per day (one 2-hour cycle
every 6 hours)
29