Filter
Top Products
J-200 Series
10. Leave spa cover open during this step to allow
excessive chemical vapors to exit spa,
protecting pillows and plastic knobs from
chemical attack. If spa is indoors, open doors
and windows for proper ventilation. Turn on all
jet pumps for one hour, then place the massage
selector knob in the center “combo” position
and open all air controls (Figure A is for all
models except the J-210). For the J-210 models
(Figure B) turn the Diverter Jet in the “combo”
position.
Note: You will need to press the jets pump button(s)
every 20 minutes since these functions have an
automatic 20 minute time-out function that turns
them off.
WARNING: RISK OF PERSONAL INJURY!
To decrease the risk of injury, drowning or entrapment, •
never leave your hot tub unattended for any reason while
the cover is open and accessible, especially to small
children and animals!
Precautions should be taken to minimize your exposure •
to chemical vapors (that could cause lung, brain, or skin
damage).
!
11. Turn off power to the spa at the circuit breaker, then drain spa as
outlined in section 12.2 “Draining And Relling” (page 35).
12. Fill spa until water covers all jets but does not touch the bottom of
the lowest headrest. DO NOT OVERFILL.
CAUTION: TO DECREASE BUILD UP ON COMPONENTS AND
MINIMIZE ACRYLIC DAMAGE.
Never ll with water from a water softener. If your water is extremely
“hard”, it is preferable to ll half-way with hard water and the rest of
the way with softened water. You may ll entirely with hard water if
you use a special water additive available from your Jacuzzi dealer.
13. Consult your authorized Jacuzzi dealer for chemical
recommendations, then add chemicals to spa water to achieve a
constant sanitizer reading within the levels recommended by the
Association of Pool And Spa Professionals/USA printed on the inside
cover of this manual.
14. Turn on all jet pumps when adding chemicals to ensure proper
mixing and leave your spa cover open until the sanitizer level falls
below 4.0 ppm to protect pillows and plastic knobs from chemical
attack.
Set all air controls to
their full open
counterclockwise position
Massage Selector
A
B
C
Figure A
Figure B
22