Filter
Top Products
J-200
15.2 Pump Does Not Operate But Light Does
Press the JETS 1 button:
If no water movement is detected, make sure power is going to 1.
the spa and check the water level. If it does not solve the problem,
contact your authorized Jacuzzi dealer or qualified service
technician.
The main jets pump 1 operates but no water ows to jets. Check the 2.
following:
• Jets may all be closed in spa. Verify all jets are in the open “on”
position (Sec. 10.5, page 27).
• Pump may not be properly primed. This can happen after the spa is
drained and relled. Press the JETS 1 button on the control panel
several times, never leaving the motor running for more than 5 to 10
seconds at a time. Turn power off and let the air out of spa plumbing
system by removing the lter cartridge (Sec. 12.1, page 32). Make
certain you reinstall the lter cartridge before turning on spa power
and restarting the jets pump 1.
15.3 Poor Jet Action
Make sure jets are in the full open “on” position (page 1. 27).
Press the JETS 1 button to make certain pump #1 is on.2.
Open all air controls to their full on position (counterclockwise).3.
Check for dirty lter. Clean, if necessary (Section 12.1, page 4. 32).
15.4 Water is Too Hot
Reduce thermostat setting.
15.5 No Heat
Check thermostat setting.1.
Keep the spa cover in place while heating.2.
Check the settings to see if your spa is in economy ltration/heating 3.
mode (page 28).
Should checking the above steps fail to correct the problem, please call
your dealer so that they may arrange service. We build the best spas in
the industry. Nonetheless, we are always striving to improve the quality
and features of our products.
Your input as a Jacuzzi spa owner is a cherished part of this process. If
you have any comments or suggestions, or if you wish to be informed on
any new products for your spa, please write to us.
CONGRATULATIONS on your good taste and welcome to the happiest
and most relaxed family in the world!
43