Filter
Top Products
13
Polar Scope Dial as indicated on the HC LCD. In this case, the Polaris will be located at a radius
of 41.5’ and an angle of 1 hour 26.8 minute, as shown in Figure 13 (b).
(a) (b)
Figure 13. Polaris displayed on 8406 hand controller (a) and Polaris located on Polar scope dial
STEP 4. Attach Dovetail Adapter
Install the Mounting Plate onto the iEQ75-GT mount. Both Vixen (included) and Losmandy-D
dovetail saddles can be used. The mounting-hole distribution on the Mount Plate is shown in Figure 14.
Figure 14. The mounting-hole distribution on the Mount Plate
STEP 7. Install Counterweight(s)
iEQ75-GT comes with two 16.5 lb (7.5 kg) stainless steel counterweights (CWs). Use one or both
CWs as required for your particular OTA. Additional CW(s) may be needed to balance a heavier OTA
(Optional CWs are available from iOptron).
CSUTION: The mount must be at the zero position when the counterweights are being installed. The
Zero Position is the position with the CW shaft pointing toward the ground, as shown in Figure 15. Use your
hand controller to move the mount.