Filter
Top Products
12
4.2. Explore GOTO and Tracking Capability
In order to experience the full GOTO capability of GoToNova
®
technology it is important to set
up the mount correctly before observation.
4.2.1. Level the Mount and Set Initial Position
Leveling is critical for good GOTO and tracking accuracy
Level the mount by observing the bubble (shown) on the base of the
mount by adjusting the tripod legs. The bubble should be in the
center of the circle. The leveling is very critical for a good goto and
tracking accuracy. You may use an additional torpedo level to
assure a precise leveling, or calibrate the existing spirit level. Turn
the mount around by pressing ► or ◄ button to make sure it is always leveled, or the bubble
stays in the same position, during rotation.
Initial Position
Each time the mount is turned on the default position is Park Position, (i.e., its altitude is 90º0.0’
and azimuth is 180º0.0’. There might be a few seconds difference) which means the “SOUTH”
mark is pointing to south and the telescope is pointing straight up at the zenith.
Note: You can always improve the initial position later during “One Star Align” or “Sync to
Target”. To set the Park Position you can:
1. Align the mount to south by releasing the azimuth lock half a
turn and rotating the mount so that the South mark faces south.
An additional compass is needed. Unlock the altitude lock (#4)
and rotate the telescope to point straight up at the Zenith. Put a
torpedo level on top of the optical tube may help. Make sure the
mount is leveled. Then turn the mount power on.
or
2. Turn the mount power on. Press the SPEED button to select
a slew speed (MAX for fast slew and 2X for fine tuning). Turn the
SOUTH mark pointing to south using ► or ◄ button. An
additional compass is needed. Rotate the telescope to point to
zenith using the ▲ or ▼ buttons. Then turn the mount power off and turn it on. Or you can press
MENU. Scroll down to “Set Telescope Coord.” Press ENTER. The default number is “Alt:
90º00.0’ and Azi: 180º00.0’”. Press ENTER to complete the initialization.
4.2.2. Setting Up the Hand Controller
Time and Site Set Up
This is critical to ensure the telescope pointing to the right direction.
1) South
2) Up
#4
Alt lock