Filter
Top Products
5 OPERATION
Invacare
®
TheraPure™Supine Whirlpool Tubs 28 Part No. 1167456
5.6 Using the Whirlpool Function
1. If the water level does not cover the whirlpool jets, push the tub fill button to auto-fill the tub.
2. After the water level covers the whirlpool jets and after bathing the resident, add Invacare Defoamer to the bath water. Refer to the Defoamer
bottle for directions.
3. Push the whirlpool button to start whirlpool jets.
4. After use, press the whirlpool button again to stop the whirlpool jets.
5. Drain the tub completely.
6. Use the stretcher lift to transfer the resident from the tub.
7. Clean and disinfect the tub. Refer to Cleaning and Disinfecting
on page 23.
5.7 Adjusting the Tub Height - 6302GADH Only
Perform one of the following:
• Press and hold the UP button. Release the UP button when the desired height is reached.
• Press and hold the DOWN button. Release the DOWN button when the desired height is reached.
ƽ
WARNING
DO NOT stand on the tub frame. Keep feet away from
tub and frame, otherwise injury may occur.
ƽ
CAUTION
DO NOT adjust the height more than three cycles (up
and down) within a ten minute period. Damage to the
actuator may result.
DO NOT adjust the tub so it hits the stretcher lift. If
necessary, adjust the height of the stretcher lift.
Otherwise damage to the tub may occur.
The tub stops automatically when the maximum
height adjustment UP or DOWN is reached.
UP Button
DOWN Button