Filter
Top Products
5 OPERATION
Part No. 1167456
27 Invacare
®
TheraPure™Supine Whirlpool Tubs
5.4 Filling the Tub
1. Use the drain plug to close the drain.
2. Position the resident (on the stretcher lift) in the tub.
3. Push the tub fill button once to start auto-fill.
4. Use the water temperature control valve to adjust the water temperature while watching the flow water thermometer. Test the water temperature
with your hand.
5.5 Using the Shower/Massage Wand
1. Turn the shower/massage on by pushing the ON/OFF button.
2. Adjust the water temperature using the water temperature valve while watching the flow water thermometer. Test the temperature with your hand.
3. Adjust the flow of the water by turning the flow control.
4. Adjust the shower spray by rotating the shower wand head.
5. Turn the shower/massage off by pressing the ON/OFF button again.
The tub will fill to a predetermined level. To stop the tub from filling during auto-fill, press the fill button a second time (there will
be a five second delay). After the tub has auto-filled, push in and hold the tub fill button to add additional water.
These instructions are to be done while holding the shower/massage wand over the tub.
Refer to the following chart for shower head adjustment settings.
Stream Pulse Massage Shower Spray Mixture of Shower Spray and Pulse Massage
Flow Control serves as a volume control and water saver.
The use of the Flow Control permits the reduction of water flow without the need for readjustment of water temperature during bathing.
A trickle of water through the Flow Control when in the closed position is normal.