Filter
Top Products
English-24
OPERATION
7. Pull the recoil starter grip slowly until you
feel compression, then pull it briskly.
If the engine won´t start in three pulls,
open the choke and try again.
8. Warm engine momentarily, then
disengage the choke until engine runs
smoothly, approximately 1/2 throttle.
9. Depress one operator presence lever.
Engage the blades and set the desired
rpm. The best cutting and bagging is
obtained with engine at top rpm.
IMPORTANT INFORMATION
Do not let recoil cord snap back by itself.
This may damage the cord or the recoil
starter assembly.
8011-498
P
ull the starter grip
WARNING!
Be sure all persons are
clear
of area before engaging the
blades.
IMPORTANT INFORMATION
To prolong spindle bearing, clutch and belt
life engage and disengage blades at
approximately ½ throttle.
8011-658
P
resence lever
8011-694
B
lade engaged