Filter
Top Products
English-34
MAINTENANCE
Adjusting the hydrostatic transmission
cable
The hydrostatic transmission cable (on the left side)
is adjusted in the following manner:
1. Remove the transmission cover. Loosen both
screws (one on each side) and lift off the
transmission cover.
2. Take apart the lower ball joint, which is locked with
a locking spring.
3. Ensure that the forward drive pedal is pressed
down completely.
4. Switch the vertical arm to the maximum position
and check that the ball and socket in the lower ball
joint are aligned.
5. Adjust the socket on the cable if needed.
6. Assemble the lower ball joint.
7. Put the ball joint’s locking spring in place.
Cable holder
The cable seat in the middle protects the cables and
the hydraulic tubes so that they do not get pinched
during turns. It is situated close to the ground and can
be damaged by objects or careless driving, especially
when reversing.
Check to ensure that it is undamaged and that the belt
guide is properly centred on the rear side of the pulley.
6008-209
6020-002
8009-364