Filter
Top Products
English – 19
START AND STOP
Fitting the
harness
• Put on the harness with
engine unit.
• Press together the hip
belt’s snap lock.
• Tension the hip belt so
that it rests on the hips.
• Tension both shoulder
belts so that the harness
presses to the back.
Quick release in
case of hazard
• Pull out the red strap.
• The hip belt and one
shoulder belt will be
automatically released at
the same time and the
harness and engine unit
will slide to the ground.
Removing the
harness
• Switch off the engine.
• Release the hip belt’s snap
lock.
• Pull one arm out of the
shoulder belt and lower
the harness and engine
unit to the ground with
the other hand.
Connection of
the engine unit
• Hang the engine unit on
the harness.
• Make sure the hydraulic
hoses are on the right side
of the harness (viewed
from behind). Exhaust
fumes will then be directed
backwards, away from the
harness.
• Fit the lock spring (A).
WARNING!
The hydraulic oil can during and after use
be very hot. Avoid contact with the skin.
NOTE!
An new machine which is
started for the first time
should be run for a maxi-
mum of half a minute with
repeated throttle starts, after
which hydraulic oil must be
replenished in the hydraulic
oil tank until the level is
correct. Repeat this
procedure until the level in
the hydraulic tank stabilises.
Start
Press the machine body to
the ground with the left
hand. (NOTE: Not with the
foot!) Grip the start handle,
pull the start line slowly out
with the right hand until a
resistance is felt (the start
hooks engage) and then make
a quick and strong pull.
Open the choke
control immediately when the engine ignites and make
repeated attempts to start until the engine starts. When the
engine starts, give full throttle and the start throttle will
automatically disconnect.
NOTE!
Do not pull the starter cord out completely and do not release
the start handle from the fully drawn position. This can cause
damage to the engine.
WARNING!
Starting with the start throttle function
connected can give an uncontrolled
activation of the cutting equipment.
A
!
!