Husqvarna 966947008 Lawn Mower User Manual


 
LUBRICATION
Husqvarna-39
Engine Oil5.
The engine oil should be changed for the rst time
after 8 hours of operation. Thereafter, it should be
changed every 100 hours.
Place the machine on a at surface.
Place a container under the engine where
the oil drain valve exits.
Remove the dipstick and open the valve cap.
Allow the oil to run out into the container.
Close the oil drain valve cap.
Replace the oil lter if necessary.
Fill with new engine oil in accordance with
Checking the Oil Level.
Start the engine. Run it for 3-5 minutes. Stop
and recheck the oil level.
Engine Oil Filter4.
Drain the engine oil in accordance with the
work description under the heading Engine
Oil/Change Engine Oil.
Remove the oil lter. If necessary, use a lter
remover.
Wipe new, clean engine oil onto the seal for
the new lter.
Mount the lter by hand with +¾ turn.
Add replacement oil.
Run the engine warm, then check that there
are no leaks around the oil lter seal.
Check the oil level in the engine, ll
if necessary. The oil lter holds 0.1 qt
(0.1 liters) of oil.
IMPORTANT INFORMATION
Used engine oil is a health hazard and must
not be disposed of on the ground or in nature;
it should always be disposed of at a workshop
or appropriate disposal location.
Avoid skin contact; wash with soap and water
in case of spills.
8062-020
Oil drain valve
8062-015
Changing the oil lter
WARNING!
Engine oil can be very hot if it is
drained directly after stopping the
engine. Allow the engine to cool to a
safe temperature rst.