Filter
Top Products
OPERATION
Husqvarna-27
Cutting Height Adjustment
8062-024
Remove spark plug wires
8062-034
1. Deck latch
2, Latch pin
3. Retainer pin
4. Height rod
Height adjustment
1
2
3
4
IMPORTANT INFORMATION
To achieve the best quality cut, the blades
should be level with the ground or slightly
tipped forward.
WARNING!
Before performing any service or
adjustment checklist
Make sure the blades and all •
moving parts have completely
stopped.
Turn the ignition switch to “OFF” •
position and remove the key.
Remove spark plug wire.•
To change the deck cutting height - hook the deck
latch onto the latch pin on each side of the frame. Use
the height of cut decal to nd the corresponding hole
for the desired height. Push the retainer pin into the
correct hole in the height rod.