Filter
Top Products
LUBRICATION
38 - Husqvarna
Cables
If possible, grease both ends of the cables and move
the controls to end stop positions when lubricating.
Ret the rubber covers on the cables after lubrication.
Cables with sheaths will bind if they are not lubricated
regularly. If a cable binds, it can disrupt operation.
If a cable binds, remove the cable and hang it
vertically. Lubricate it with light engine oil until the oil
begins to escape from the bottom.
Tip: Fill a small plastic bag with oil and tape it so that
it seals against the sheath and allow the cable to hang
vertically from the bag overnight. If you do not succeed
in lubricating the cable, it must be replaced.
Front Wheel Mount1.
Lubricate with a grease gun, one zerk for each wheel
mount, until the grease is forced out. Use only good
quality bearing grease. Grease from well-known brand
names (petrochemical companies) usually maintains a
good quality.
Front Wheel Bearings2.
Lubricate with a grease gun, one zerk for each set of
wheel bearings, until the grease is forced out. Use only
good quality disulphide grease.
8062-029
Lubricating the front wheels
Throttle and Choke Cables3.
Lubricate the cable ends at the carburetor with the oil
can. Move the controls to the end points and lubricate
again.
The throttle cable is also lubricated at the control when
the control console is removed.
8011-605
Lubricate cables