Filter
Top Products
English – 71
LUBRICATION SYSTEM
Saws 61, 268, 272XP.
Dismantle the oil pump as follows:
1. Remove the lock washer (A), washer,
spring and adjuster screw (B).
2. Remove the locking lacquer and undo
screw (C).
3. Knock the edge of the pump housing
against a piece of wood so that the
pump piston (D) slides out of the
housing.
4. Remove the pinion (E) with washers
and springs.
5. Remove the pin (F).
6. Remove the seal (G).
7. If necessary remove the O-ring (H).
A
H
F
B
G
E C D
F
A
D
E
CB
Saws 281XP and 288 XP.
Dismantle the oil pump as follows:
1. Undo the adjuster screw (A).
2. Remove the plug (B) with pump piston
(C) and spring with washers.
3. Dismantle the O-ring (D). Replace if
necessary.
4. If necessary, replace the seal (E).
5. If necessary, replace the O-ring (F).
Eng, p 40-82 96-09-13, 10.2771