Filter
Top Products
English – 45
All saws except 3120
3120
Slide the spring over the knee link's stud and
press down the opposite end of the spring into
its recess.
Fit the cover over the spring.
Fit the spring and screw onto the pressure
rod on the brake band.
Note! Plastic sleeve.
Bottom the screw onto the pressure rod
thread and back off 4-5 turns.
Grease and fit the ratchet. Set the unit in a
vice, positioned in the jaws as shown below.
!
WARNING!
If the clutch cover slides out of
the vice's grip the spring can fly
out with immense force resulting
in personal injury!
3120 continues on next page.
Continues on next page.
SAFETY EQUIPMENT
Eng, p 40-82 96-09-13, 10.1445