Filter
Top Products
English – 117
Assembly
CRANKCASE AND CRANKSHAFT
Other saws
NOTE!
Ensure that dirt and foreign particles
do not enter the bearing.
If the bearing needs to be fitted proceed
as follows:
A. Heat the crankcase half in question to
200°C.
B. Wear protective gloves, take out the
crankcase half and press in the bearing.
C.Let the crankcase half cool before
continuing work.
Fit the bearing and seals on the crankshaft.
Grease the seals.
Continue assembly as described on
page 111.
Saws 36 and 41.
Saws 40 and 45.
See page 120.
WARNING!
The crankcase halves can be hot.
Risk of burns. Wear protective
gloves.
!
If new seals need to be fitted in the
crankcase, grease the sealing surfaces
and knock in the seals using respective
punchs (see ”Service tools”).
The seals can also be fitted when the
crankcase is in position.
Assembly position. See pages 123 and 124.
See continuation on next page.
Eng, p 83-124 96-09-13, 11.34117