Husqvarna 917.27909 Lawn Mower User Manual


 
ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes,
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness,
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier, Standard
wrench sizes are listed.
(1) Pliers (1) Tire pressure gauge
(1) 9/16" wrench (1) Utility knife
(2) 1/2" wrenches (1) 3/4" wrench
When right or left hand is mentioned in this manual, it means
when you are inthe operating position (seated behind the
steering wheel),
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
Remove all accessible loose parts and parts cartons
from carton,
Cut along dotted lines on all four panels of carton,
Remove end panels and lay side panels flat,
Remove mower and packing materials,
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
ATTACH STEERING WHEEL (See Fig. 1)
Remove Iocknut and large flat washer from steering
shaft,
Position front wheels of the tractor so they are pointing
straight forward.
Slide the steering sleeve over the steering shaft,
Position steering wheel so cross bars are horizontal
(left to right) and slide onto steering wheel adapter,
Secure steering wheel to steering shaft with Iocknut
and large flat washer previously removed, Tighten
securely,
Snap steering wheel insert into center of steering
wheel,
Remove protective materials from tractor hood and
grill,
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO
ROLLOFF SKID.
STEERING WHEEL
LOCK NUT
"_L-_LARGE FLAT WASHER
STEER,NG__.___ STHEEER/_
WHEEL
APTOR
@
STEERING
STEERING
SLEEVE
FIG. 1
CHECK BATTERY (See Fig. 2)
Lift hood to raised position.
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this manual
for charging instructions).
LABEL
FIG. 2
6