Filter
Top Products
English-47
TROUBLE SHOOTING
Outside If this occurs in isolated areas it may
be due to interference from metallic
objects (perimeter fence, reinforce-
ment bar) or buried cables in the
vicinity.
Try to move the boundary wire.
The working area slopes too much. Check that the boundary wire has
been routed correctly.
The boundary wire has been routed
the wrong way around an ”island”.
Check that the boundary wire has
been routed in accordance with the
installation instructions.
The boundary wire is too close to the
edge of the working area.
Check that the boundary wire has
been routed correctly.
Low battery voltage Auto Mower cannot find the charging
station.
Change the position of the charging
station.
The battery is defective. Contact your dealer to replace the
battery
Wrong PIN code Wrong PIN code has been entered.
Three attempts are permitted, the
keypad is then blocked for five min-
utes.
State the correct PIN code.
No drive Auto Mower has become caught in
something.
Free the mower and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried
before using the mower.
No contact in charg-
ing station
The Auto Mower makes poor contact
with the contact stripes in the charg-
ing station.
Check that the Auto Mower has
docked correctly in the charging sta-
tion.
Charging station
blocked
The contact between the charging
strips and contact strips may be poor
and the Auto Mower has made a
number of charging attempts.
Place the Auto Mower in the charging
station and check that the charging
strips and contact strips make good
contact.
An object is obstructing the Auto
Mower
Remove the object.
Stuck in charging
station
An object is preventing the Auto
Mower from reversing out of the
charging station.
Remove the object.
Upside down The Auto Mower leans too much or
has turned over.
Turn the mower the right way up.
Empty battery The Auto Mower is set in MAN oper-
ating mode.
This behaviour is normal; no action
required.
Fault message Cause Action