Filter
Top Products
English-25
INSTALLATION
7. Refit the cover on the charging station. Ensure the
three guides on the charging station enter the right
holes in the cover.
G. Checking the installation
Check the loop signal by looking to see what indication
the green LED on the charging station is giving.
• Lit =
the signal is okay.
• Single flashing every other second =
break in the loop and no signal found.
• Double flashing every other second =
signal found, but the wire is probably damaged.
Check all wire connections.
H. Linking the Auto Mower to the charging
station
1. Open the control panel cover.
2. Set the main switch to the ON position.
A start-up sequence begins when the Auto Mower
is started for the first time. The following is
requested: Language, time format, correct time,
date format and correct date.
3. Place the Auto Mower in the charging station.
4. State the four digit PIN code. All combinations
except 0000 are permitted.
If you own more than one Auto Mower and charg-
ing station in the same garden, each mower must
have its own PIN code.
If you have one Auto Mower for several gardens
with one boundary wire and charging station per
garden the mower can have the same code for all
gardens. The distance between the boundary wire
loops must be at least 20 cm.
When you have chosen a PIN code with the Auto
Mower placed in the charging station, the mower and
charging station are then linked to each other.
3012-270
3012-282