Filter
Top Products
English-
20
INSTALLATION
Remeber the following with regard to the working area
boundaries:
• The Auto Mower can mow areas with a gradient of
up to 1: 3 (33 cm/m) inside the working area. Areas
that slope more must be demarcated by the bound-
ary wire. If any part of the working area’s outer edge
has a gradient of 1: 5 (20 cm/m) or more, the wire
should be laid inside where the slope starts. The
Auto Mower may find it difficult to turn at the loop
where the ground slopes heavily.
• Use the boundary wire to demarcate areas inside
the working area, for example, flower beds and
fountains. Lay the cable up to the area, around it
and then return along the same route. If staples are
used, the cable should be laid under the same sta-
ple on the return route.
• Obstacles that can withstand a collision, for exam-
ple, trees or bushes higher than 10 cm, do not need
to be demarcated by the boundary wire. The Auto
Mower will turn when it collides with this type of
obstacle.
However, for the most gentle and silent operation, it
is preferable to demarcatee all fixed objects in and
around the working area.
• Obstacles that slope slightly, for example, stones or
large trees with raised roots, should be demarcated
or removed. The Auto Mower can slide up onto this
kind of obstacle causing the blades to be damaged.
Remember the following with regard to secondary
areas and passages:
• If there are secondary areas close to the main area
the boundary wire should be laid so that these
areas form an ”island” outside of the main area.
Secondary areas are working areas without the
charging station, but which are encircled by the
same boundary wire as the main area. The Auto
Mower must be moved manually between the main
and secondary areas.
If the garden consists of two areas where one area
is much smaller than the other and the areas are
only connected by a very long narrow passage, it
may be suitable to create a secondary area.
3012-108
Minimise
3012-231
3012-279
Secondary area
Main area