Filter
Top Products
English---9
545133423 Rev. 4 9/6/07
DESCRIPTION
Ground wire
S The ground wire (G) reduces static
build--up during operation in dry condi-
tions.
Inlet cover
S An inlet cover (H) is located on the side
of the fan housing. Opening this cover
allows acc ess for cleaning and inspect-
ing the impeller (125B
X--SER IES
and
125BV
X--SER IES
only). I f the vacuum tube
is used, it must be fitted to the opening in
the inlet cover. To open the inlet cover,
use a tool to lift the edge of the cover
opposite the hinge (indic ated by arrow
on inlet cover).
Cutters
(125B
X--SER IES
and 125BV
X--SERIES
)
S T wo cutt ers (J) are fastened to the impel-
ler . The cut ters ar e there to mulch leaves
and other debr is that have been va cuumed
before they enter the collect ion bag.
Blower tube and nozzle
NOTE:
The tube clamp bolt and nut must
be installed pr ior to initial use (see the gen-
eral description of the blower on page 6).
S The blower tube (K) has a pegged slot
mounting system to the unit. To install or
remove the blower tube (or col lect ion bag
tube for the 125BV
X--SERIES
), the tube
clamp bolt must be removed. A lign slot in
the blower air outlet with the raised rib on
the tube and insert tube until the holes in
the tube and housing align. Re--insert the
tube clamp bolt and tighten.
S The nozzles (
L
)ha
v
e a bayonet mount
for connection to the blower tube. Air is
channeled through the blower tube to the
nozzles, where the air discharge velocity
increas es and the air stream discharge
pattern is formed to provide best perfor-
mance. The length of the blower tube
can be adjusted by twisting the nozzle to
the left to disengage the bayonet mount
and sliding t he nozzle to the appropriate
position. Twist the nozz le to the right until
a clic k is felt to resecure the nozzle.
Starter device and starter handle
S The st arter device (M) is located on the
side of the engine shrouding and en-
gages the crankshaft only when the
starter handle (N) is pulled.
Fuel cap
S The fuel cap (O ) is located at the rear of
the engine shr ouding on the fuel tank
and has a seal t o prevent fuel from leak-
ing out.
Air filter
S The air filter (P) consists of a fiber filter
medium in a res ilient frame. The air filter
should be cleaned at specific intervals
(see Maintenance section). Otherw ise,
the blower will consume too much fuel,
the performance will be reduced and an
oily deposit may form on t he spark plug
electrodes.
W ARNING: Never start the blower
if the inlet cover is not close d, is
damage d or cannot be closed
(except if the vacuum tube is fitted).
H
K
J
M
N
O
P
G
L