Filter
Top Products
MAINTENANCE
English – 33
Checking the right-hand brake trigger
Check that the right hand guard is not damaged and that
there are no visible defects, such as cracks.
Push the trigger up and forwards to check that it moves freely
and is securely hinged to the clutch cov
er.
Never carry or hang the saw by the trigger! This could
damage the mechanism and disable the chain brake.
Checking the brake trigger
Place the chain saw on firm ground and start it. Make sure
the chain does not touch the ground or any other object. See
the instructions under the heading Start and stop.
Grasp the chain saw firmly, wrapping your fingers and
thumbs around the handles.
Apply full throttle and activ
ate the chain brake by tilting your
left wrist forward onto the front hand guard. Do not let go of
the front handle.
The chain should stop immediately.
Throttle lockout
• Make sure the throttle control is locked at the idle setting
when the throttle lockout is released.
• Press the throttle lockout and make sure it returns to its
original position when y
ou release it.
• Check that the throttle control and throttle lockout move
freely and that the return spr
ings work properly.
• Start the chain saw and apply full throttle. Release the
throttle control and check that the chain stops and
remains stationar
y. If the chain rotates when the throttle
control is in the idle position you should check the
carburetor idle adjustment.
Chain catcher
Check that the chain catcher is not damaged and is firmly
attached to the body of the chain saw. Replace it if
necessary with an aluminium chain catcher (is available as
spare part).