Filter
Top Products
ASSEMBLY
English – 17
Fitting the bar and chain
346XP TrioBrake, 353 TrioBrake
Check that the chain brake is in disengaged position by
moving the front hand guard towards the front handle.
Remove the bar nuts and remove the clutch cover (chain
br
ak
e). Take off the transportation ring (A).
Fit the bar over the bar bolts. Place the bar in its rearmost
position. Place the chain o
ver the drive sprocket locate it in
the groove on the bar. Begin on the top edge of the bar.
Make sure that the edges of the cutting links are facing
f
orw
ard on the top edge of the bar.
Fit the clutch cover and locate the chain adjuster pin in the
hole in the bar. Check that the drive links of the chain fit
correctly over the drive sprocket and that the chain is
correctly located in the groove in the bar. Tighten the bar nuts
finger tight.
Tension the chain by turning the chain tensioning screw
cloc
kwise using the combination spanner
. See instructions
under the heading Tensioning the chain.
The chain is correctly tensioned when it does not sag from
the underside of the bar
, b
ut can still be turned easily by
hand. Hold up the bar tip and tighten the bar nuts with the
combination spanner.
When fitting a new chain, the chain tension has to be
chec
k
ed frequently until the chain is run-in. Check the chain
tension regularly. A correctly tensioned chain ensures good
cutting performance and long life.
345e TrioBrake
Check that the chain brake is in disengaged position by
moving the front hand guard towards the front handle.
Remove the knob and remove the clutch cover (chain brake).
Take off the transportation ring.
!
WARNING! Always wear gloves, when
working with the chain.