Filter
Top Products
118 – English
Other saws.
Using the assembly tool for the chain saw in
question assemble the crankshaft in the
clutch side’s crankcase half.
Some saws have a sharp edge on the crank-
shaft which can damage the seal. The as-
sembly sleeve should be used when working
on these saws. See ”Tools”.
NOTE! Place the oil tank’s vent hose in
the pocket above the tank cap in the
equivalent crankcase half.
Grease and fit a new crankcase gasket (A).
Check that the guide pin (B) is in position and
fit the other crankcase half.
Using the assembly tool for the chain saw in
question, fit the two crankcase halves. Pull
until the gasket is clamped between the two
crankcase halves.
NOTE!
Continuing to pull with the assembly
tool after the gasket is clamped will
damage the crankshaft.
CRANKCASE AND CRANKSHAFT
See page 120.
Saw 40 and 45.
NOTE!
Ensure that the connecting rod does
not jam against the crankcase when
the crankcase and crankshaft are
assembled.
See continuation on next page.
Eng, p 83-124 96-09-13, 11.35118