Filter
Top Products
112 – English
PISTON AND CYLINDER
Other saws
Fit the four bolts under the crankcase.
Tightening torque, see ”Service data”.
Fit the four cylinder bolts (B).
On saw 394, connect the anti-vibration spring
(A) to the cylinder. The bolts are tightened
using a 4 mm allen key (smaller saws) or
3/16” allen key (larger saws).
BA
Fit the intake manifold and the insulation wall
between the cylinder and carburettor.
Fit the following parts:
• Cylinder cover. See operating instructions.
• Spark plug. See operating instructions.
• Carburettor.
• Muffler.
Carry out a pressure test as set out on the next page.
If a new piston or cylinder has been fitted the saw must be run-in for 3-4 hours with the carburettor
set to the basic settings. See the operating instructions for the saw in question.
Saws 36, 40, 41 and 45.
Saws 36 and 41.
Saws 40 and 45.
Fit the tank unit.
Fit the ignition coil and its cables.
Fit the decompression valve.
Eng, p 83-124 96-09-13, 12.57112