Filter
Top Products
22
HUSKY 1550
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
Wand is malfunctioning Test wand to ensure that it is not malfunctioning.
Gun is not operating properly Remove Wand from the Gun and squeeze trigger to
ensure that the water is coming out of the front of the
Gun at a rate equal to the Garden Hose.
Wand - Attaching
To attach the Wand apply some moderate
downward pressure on the Wand (In the direction
of the trigger) while simultaneously twisting the
wand a 1/4 of a turn counterclockwise. (It may
help if you set the gun vertically on a flat surface
with the wand pointing upwards).
The two tabs on the end of the Wand must slide
all the way in before the Wand will twist and
lock.
If this does not work remove the o-ring from
the end of the wand and attach it without the
o-ring. If the wand attaches, you will need to
replace the o-ring.
Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Wand - Removing Release the back pressure in the Gun/Hose.
Remove the Garden Hose from the unit and
squeeze the trigger of the Gun.
Apply some moderate downward pressure on
the Wand (In the direction of the trigger) while
simultaneously twisting the wand a 1/4 of a turn
clockwise. (It may help if you set the gun vertically
on a flat surface with the Wand pointing upwards).
For additional assistance you can email us at:
customerservice@huskypowerwasher.com.