Filter
Top Products
19
HUSKY 1550
8.0 TROUBLESHOOTING
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
Detergent is not dispensing The suction tube located in the
detergent spray bottle assembly
has been disconnected or clogged.
Remove the soap lance assembly from the
detergent bottle. Make sure that the clear tube
is properly connected to the soap lance. If it is
not connected then reconnect it.
Detergent to Water ratio Your Powerwasher draws detergent at a 10:1 ratio.
Most pressure washer detergents are generally
concentrated within that range so minimal
adjustment is required.
If you feel like you are using more detergent than
is required for the application you can dilute it with
regular tap water.
Detergent - What to use We recommend that you use a cleaner which is
specifically designed for power washers. There
are different kinds available depending on the
application. Check with your local Home Depot
store for the product which is best suited for your
needs.
Never use Bleach, Ammonia or Hot
water in the unit.
Circuit breaker trips or Fuse
blown in Fuse Box
Circuit overload Check that the circuit is rated at 15 amps or
greater. Make sure the unit is plugged into a
dedicated circuit.
Extension cord too long or wire
gauge too small
Use proper extension cord as recommended in
owner’s manual.
Nozzle partially blocked Clean Nozzle as instructed in section 6.2.
Excessive pressure Clean Nozzle as instructed in section 6.2
GFCI Plug installation
GFCI Plug malfunction
For GFCI reset procedures see owner’s manual
section 4.3.
For instructions regarding the GFCI Plug installation
or malfunction please email us directly at:
customerservice@huskypowerwasher.com
Gun/Hose - Leaking water Gun/Hose will need to be replaced. Replacement parts
are not available for the Gun/Hose. Email us at:
customerservice@huskypowerwasher.com
for assistance or order online at:
www.huskypowerwasher.com.
Leaking Oil from Pump A small amount of leakage is
normal
If leakage occurs please contact us directly at
customerservice@huskypowerwasher.com
Leaking water from bottom
of unit
Machine Inlet connection is
defective
Check the Machine Inlet at the back of the unit
to ensure that water is not leaking from it. If the
connection is leaking it will have to be replaced.
Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.