Filter
Top Products
21
HUSKY 1550
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
No water coming out of
Wand
Gun/Hose Assembly is defective Attach the Gun/Hose to the front of the unit with
no wand attached to the Gun.
Squeeze the trigger of the gun to ensure that water
comes out of the front of the Gun at a rate equal
to the Garden Hose. If no water comes out of the
Gun, remove the gun and the hose to ensure that
water flows out of the pump. If it does, the gun will
need to be replaced. Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Trigger will not move Gun Safety Lock in engaged Release Safety Lock as instructed in Manual.
Unit will not start
Note: Unit will only start when
trigger is depressed.
Unit stops while operating
Unit is not turned on Press ON/OFF Switch into ON position.
Loose or disconnected Plug Reconnect Plug.
Defective GFCI Plug Perform GFCI reset procedure as instructed in
Section 4.3. If the GFCI does not reset it will
need to be replaced. Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Extension Cord length or gauge
incorrect
Use proper Extension Cord as instructed in section
4.3.
Gun trigger not operating
properly
Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Defective Gun Remove the Gun and Hose assembly from the
front of the unit. Aim water stream away from
electric source and switch the unit into the ON
position. If the unit starts and water comes out
of the front, the Gun may need to be replaced.
Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Tripped Pressure washer
Thermal Switch
Allow to cool and restart unit.
Defective ON/OFF Switch
Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Unit will not stop when trigger
is released
Screen filter is clogged Clean the Screen filter as instructed in the section
6.4.
Garden Hose is kinked or
leaking water
Make sure the Garden Hose is laid out flat and
there are no kinks in it. The hose should not be
wrapped on a storage wheel. Make sure the
faucet is open all the way and there is a full
volume of water reaching the unit.