Filter
Top Products
Check that parts are delivered correctly: Remove the
mower from the packaging and check that all loose items
have been supplied correctly. Refer to the delivery check-
list opposite and the general assembly. If any items are
missing contact, your local Hayter dealer.
Assemble the handlebar: Unscrew the handlebar securing
knobs sufficiently to allow the handlebar to be pivoted.
Move the engine stop lever away from the engine to avoid
damage and unfold the handlebar to its operating position.
Ensure that both Knobs are on the outside of the handlebar
and the cable guide is positioned as shown. Tighten to
secure handlebar in position.
IMPORTANT - PREVENT DAMAGE : When unfold-
ing the handlebar, take care to ensure that the controls
and cables do not become damaged. Always replace
damaged controls and cables before using the mower.
Adjust height of handlebar: Unscrew the two larger
Knobs at base of handlebar sufficiently to allow it to be
moved to the upper, middle or lower position. Secure in
best position for comfort. Ensure that both sides are set to
the same height.
Assemble the grassbag: Remove the long ribbon label by
cutting it off close to the grassbag. Discard the ribbon label.
WARNING - AVOID ENTANGLEMENT : Completely
remove this ribbon before using the mower
Grassbag attachment: Raise the rear deflector. Lower the
grassbag through the handlebar and hook in position behind
the deflector springs. Lower the grassbag to rest against the
rear of the mower. Finally, lower the rear deflector to rest
against the top of the grassbag.
ASSEMBLY INSTRUCTIONS
485101MT210999A
1.12
1.12
ASSEMBLING THE MOWER FOR THE FIRST TIME
DELIVERY CHECKLIST
Description Quantity
Grassbag
Owner’s Handbook
Warranty Registration Card
1
1
1
CS005
CS006
CS009
CS007
CS072