Filter
Top Products
Pre-Start Checks:
1. IMPORTANT ! Prior to first using the Cultivator, the Engine MUST be filled
with a high quality SAE 10W-30 grade engine oil until the level of the oil is
indicated as “FULL” on the Oil Dipstick. To do so, unscrew and remove the Oil
Dipstick located on the Engine Crankcase. Fill the Engine Crankcase with the
Proper amount of oil. Then, screw the Dipstick back into the Oil Fill Hole. (For
additional information, refer to the engine manufacturer’s manual.)
(See Figure B.)
2. Before the first use, remove the Engine’s Fuel Tank Cap and fill the Fuel Tank with
unleaded
gasoline. Then, replace the Fuel Tank Cap. Thereafter, check the Fuel
Tank for the amount of unleaded gasoline. Refill the Fuel Tank
only
with unleaded
gasoline.
BEWARE of possible buried obstacles such as cable, conduit, and irrigation lines.
2. The Upper Handle (66) is folded for shipping purposes. Loosen the Grip Handles
(67) located on each side of the Upper Handle. Unfold the Upper Handle to its
normal working position. Then, firmly retighten each Grip Handle to secure the
Upper Handle in place. (See Figure A.)
OPERATING INSTRUCTIONS
OIL DIPSTICK
“FULL” LEVEL
INDICATOR LINE
ENGINE CRANKCASE
FIGURE B
To Start And Operate The Cultivator:
1. Move the Cultivator to the position where you wish to begin tilling the soil.
2. If necessary, adjust the Depth Skid (57) in order to till the soil at a desired depth
SKU 91959 For technical questions please call 1-800-444-3353 PAGE 9