Filter
Top Products
SKU 91959 For technical questions please call 1-800-444-3353 PAGE 12
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST
AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEI-
THER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION
OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/
OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACE-
MENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS,
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARIS-
ING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACE-
MENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
3. Before each use, check to make sure the Engine’s oil level is adequate. If neces-
sary, fill the Engine’s Crankcase until the oil level is indicated as “FULL” on the
Oil Dipstick. (See Figure B.)
4. Before each use, With a soft brush, vacuum, or compressed air, remove all debris
from the Cultivator. Then, use a premium quality, lightweight machine oil to lubri-
cate all moving parts except the Belt (12), Pulley F (3), and Pulley J (31).
5. Every 25 hours of use drain the old Engine oil and replace with a high quality
SAE 10W-30 grade engine oil, making sure the oil level is indicated as “FULL” on
the Oil Dipstick. Make sure to contact a local environmental or recycling
center for proper disposal of old oil.
6. Belt replacement: Should it become necessary to replace the Belt (12) it is
recommended that only a
qualified, certified technician
perform this procedure.
7. Every 300 hours of use, have a
qualified, certified technician
perform thorough
maintenance on the Cultivator and its Engine.
Adjusting The Tiller Tines
Part # 45 Shaft, and the Tines, are assembled with Cotter Pins (39) and Pin Shaft
(38). The Shaft (45) has adjustment holes in it. To change the spacing between the
Tines remove the Cotter Pins then remove the Pin Shaft (45). Adjust the Tiller Tines
to the desired placement then insert the Pin Shaft (38) through the Shaft (45). Insert
the Cotter Pins (39) in the Pin Shaft (38) to secure it.
8.
REV 11/05