Filter
Top Products
Page 19For technical questions, please call 1-800-444-3353.SKU 67255
Flip the Chain Guide Bar over before 6.
mounting the new saw Chain. This
will ensure that the Chain Guide Bar
wears evenly over time.
Direction of Saw
Chain Cutters
Saw
Guide
Bar
Nose
Figure 16
7. Place the new Saw Chain around
the Sprocket and over the Guide
Bar. Make sure the Cutters of the
Saw Chain are facing away from the
Chain Saw along the top edge of the
Guide Bar. Fit the Chain in the groove
around the Guide Bar.
Replace the Drive Cover (3).8.
Note: The tab on the Driver Cover (3)must
slide into a slot on the Right Housing
(29) and the lock-pin to be locked into
the housing prior to securing the nut.
Do not force.
Finger tighten the Nut, then tension 9.
the Saw Chain following the steps in
the Saw Chain Tension section, on
page 12.
WARNING! If the supply cord of this
power tool is damaged, it must be
technician.