Filter
Top Products
Page 16For technical questions, please call 1-800-444-3353.SKU 67255
Figure 9
2
ND
1
ST
CUT UNDERBUCK
(1/3 DIAMETER)
11.
To Underbuck is when the log is
supported on one end, and a cut 1/3
the diameter of the log is made from
the underside of the log. Then, the
Figure 10
1
st
2
nd
CUT UNDERBUCK (2/3 DIAMETER)
ST
CUT
12. When the log is supported on both
ends, cut 1/3 of the log’s diameter
from the top overbuck. Then, make
lower 2/3 diameter of the log to meet
Figure 11
SIDE WHEN CUTTING
13.
When bucking on a slope, always
stand on the uphill side of the log.
When “cutting through”, to maintain
complete control release the cutting
pressure near the end of the cut
without relaxing your grip on the
Chain Saw Handles. Do not allow
the Saw Chain (72) to contact the
ground. After completing the cut,
wait for the Saw Chain to stop before
moving the Chain Saw. Always turn
off the Chain Saw before moving from
tree to tree.