Filter
Top Products
-18-
Model G0639 22-Ton Hydraulic Log Splitter
Splitting Logs
4. Move the ram and beam assembly to the
vertical position and lock it in place with
safety chain shown in
Figure 21.
5. Closely inspect all components and hydraulic
lines for any evidence of damage, wear,
or unsafe conditions; and correct before
proceeding any further.
6. Put on your safety glasses, hearing protection,
and thick leather gloves.
7. Start the engine, and place the log to be split
in the splitting cradle
.
8. Make sure bystanders are out of the work
zone and the zone is clear of split lumber
.
9. While keeping hands clear of the splitting
wedge, use the control lever to split the log,
retract the wedge, and remove the split log
from the work zone.
Figure 21. Log splitter positions.
Rear Landing Leg
and Lock Pin
Work Zone is
Approximately a
6-Foot Sphere
Control Lever
Splitter
Wedge
Splitting
Cradle
This log splitter is ONLY designed to split wood
with the grain direction. DO NOT attempt to split
or crush wood against the grain, or split brick,
concrete blocks, or rock. If you do, you will dam
-
age the machine, void the warranty, and possibly
severely injure or kill bystanders or yourself.
To operate the log splitter:
1. Read and understand this entire manual
and the Briggs & Stratton engine
operators
manual.
2. Verify that your job site location meets at
least the minimum requirements for safety
and use. Refer to Job Site Considerations
on Page 16 for details.
3. Lower the rear landing leg and secure it in
place with the lock pin.
Beam Safety Chain