Filter
Top Products
-12-
Model G0639 22-Ton Hydraulic Log Splitter
14. Lock the beam in place in the horizontal posi-
tion with the spring loaded lock pin shown in
Figure 11.
12. Using a mechanical lifting device that can
support at least 1000 lbs., lift the cylinder and
beam assembly and secure it in the hinge
with the hinge pin.
13. Bend the hinge pin cotter pin so the hinge pin
cannot fall out
.
Figure 11. Beam lock.
8. Install the rear leg onto the frame with the
M10-1.5 x 75 pivot bolt, flat washer, and lock
nut as shown in Figure 8.
9. Raise the leg and lock it in place with the
lock pin and 2 x 15mm cotter pin as shown in
Figure 8.
Figure 10. Beam and cylinder hinge pin.
Beam and Cylinder
Hinge Pin and Cotter Pin
Figure 9. Main lifting location.
10. This cylinder and beam assembly is top
heavy, so loop a lifting strap rated for at least
1000 lbs through the front beam lock eyes at
the location shown in
Figure 9.
Figure 8. Rear leg installation.
Pivot Bolt
Rear Leg
Lock Pin
11. Add additional lifting straps or chains as
required for your lifting apparatus so the
beam can be lifted without a sudden load
shift.