Filter
Top Products
9
2-5 Attaching The Aluminum Grass
Container To The Unit
NOTE: IT IS RECOMMENDED THAT 3 PEOPLE
ASSIST IN MOUNTING THE CONTAINER.
With three people available, two can lower the container
onto the frame while the third person inserts the pivot
pins P#(K0172) through the holes. Insert the pins from
the outside to the inside. Secure with (1) 5/8” washer
P#(06442800) and (1) 5/32” x 2-5/8” hair pin clip
P#(06715000) per pivot pin. Reattach the bottom ends of
the door opening linkages to the main frame by using (1)
Rue-Ring cotter pin P#(06715100) per side. To test the
functionality of the dump mechanism, pull the lift handle
away from the unit and lift upward (Figure 10). The door
of the container should open and the box should pivot
clockwise towards the ground.
2-6 Aluminum Grass Container Inlet
Attachment
The inlet will need to be attached to the container
(Figure 13). Open the container, push the inlet from the
inside of the container through the hole in the container
to the outside. Orient the inlet opening to face the
ground. Use the tabs P#(00191900) inside of the box to
hold the inlet in place. It is recommended that two
people perform this step. That way, one person on the
inside of the container can position the tabs, while the
other person tightens the bolts. Looking at the outside of
the container, the most difficult tab to tighten down will
be the tab at the 4-5 o’clock position. Tighten that tab
first. Then proceed to tighten the others.
2-7 Adjusting The Dump Mechanism
The linkage may be adjusted in two places, at the
adjusting screw P#(07068800) and the latch assembly
items. See Figures 10 & 12 for visual clarification. To
change the door closure tightness, screw the adjusting
screw in or out. To adjust the latch, change the length of
the latch rod by screwing the latch adjusting ball joint in
or out. The latch hook pivot should be in the middle of
the slot in the latch hook pivot plate. Slide the pivot back
or forth and then re-tighten.
Figure 14 Aluminum
Grass Container
Exploded View
(1) 00193900
Box Top
(1) 00193800
Screen
(4) 00191900
Inlet Clamp
(1) 00192000
Inlet
(1) 00192100
Box Handle
(1) 07538700
Handle Grip
(1) 08354400
Latch Spring
(2) 00192200
Linkage Rod
(2) 06545600
Adjusting Nut
(1) 00192300
Latch Rod
(2) 07068800
Adjusting Screw
(1) 00192400
Adjusting Ball Joint
(1) 00193200
Box Bottom
(1) 00192500
Latch Hook
(1) 00193100
Base Frame
(1) 00192600
Latch Hook
Pivot Plate
(1) 00192700
Base Frame
Pivot Mount
(1) 00192900
Door Frame
Assembly
(1) 00193000
Plastic Door
(1) 00193300
Upper Door
Member
(1) 00193400
Box/Door
Frame
(1) 00193700
Screen Support
(1) 00193600
Box Back &
Sides
(1) 00193500
Handle Mount
(1) 00194000
Fill Gage
(2) 00194100
Linkage Pin
(2) 00192800
Pivot Bracket