Filter
Top Products
14
2-13 Adjustment Of The Lengths Of
The Hoses
The hoses in steps 2-14 and 2-15 must be cut to fit your
machine. Follow steps 2-14 and 2-15. Do not cut the
hoses until you have tried to fit them on your machine.
Remember that the hoses have to be long enough to
allow for enough clamping surface between the inlet,
blower assembly, and the deck boot.
2-14 Attachment Of The Upper Hose
Slide a 5”-6” upper hose clamp P#(03022400) onto both
ends of the 6” upper hose (Figure 21). Then slide one
end of the 6” hose onto the inlet. Make sure there is
about a two-inch overlap between the hose end and the
container inlet. Proceed to slide the opposite end of the
6” hose onto the outlet of the blower assembly. See
Figure 19 for details. Make sure both ends of the hose
are clearly attached to the inlet and the blower assembly
inlet. Tighten the hose clamps.
2-15 Attachment Of The Lower Hose
To The Blower Cone
Slide a 7”-8” hose clamp P#(03022400) over both ends
of the lower hose. Then proceed to slide the lower hose
onto the blower cone. Tighten the hose clamp. The
assembly should look like Figure 21.
2-16 Attachment Of The Lower Hose
To The Boot
Take the unattached end of the lower hose and slide it
over the circular end of the boot. Use the lower hose
clamp to secure the hose to the boot (Figure 21). Tip:
Before securing clamp rotate hose counter-clockwise
(away from yourself) approximately 1” to add in retaining
boot to mower deck.
2-17 Front Weight Assembly
Place (1) weight bracket P#(00195300) over each front
caster. Fasten each weight bracket to the front caster
loosely, by using (1) 3/8”-16 x 3-1/2” u-bolt
P#(07068600) and (2) 3/8”-16 flange nuts P#(06542000)
per bracket. When installing the 100 lb.weight you
should have another person help position the weight
onto a floor jack. Using the floor jack will make installing
the weight much easier. Lift the weight up to the bottom
of the weight brackets. Fasten the weight to the weight
brackets by using (1) ½”-13 u-bolt P#(07068700) and (2)
½”-13 flange nuts P#(06543600) per bracket. Once the
weight is secure tighten all nuts. See Figure 22 for more
detail.
Figure 21 Hose Assembly
Figure 22 Weight Assembly
Figure 20
Boot Rod
Mower Deck
Deflector Shield Mount
Boot Hanger
Notch
Boot Plate
Inlet
Upper Hose
Boot
Lower Hose
Weight
Weight Bracket
Caster