Filter
Top Products
7
Operation
Be certain that all shields, guards, and interlock
switches are in the correct position and operating
properly.
Before starting the engine, put the PTO lever in the
“OFF” position and the gear shift lever in the neutral “N”
position.
Check the operation of the operator presence controls
before operating the tractor. With either the PTO or the
direction control lever engaged, the engine should run
only if at least one of the operator presence switches is
depressed.
Do not use the equipment in the dark without adequate
lighting.
Keep away from moving parts. Stay clear of the
attachment when the engine is running.
Do not let people other than the operator near the
operating equipment. Never direct discharge of
material towards bystanders. The operator is
responsible for the safety of bystanders.
Operate the attachment only on safe surfaces as
prescribed in the attachment manual. Disengage the
attachment drive when moving the tractor to and from
work areas.
Use a slow speed and engage the shift lever slowly
when operating on slopes.
Travel across slopes, not up and down. Use extreme
caution when changing direction on slopes. Do not
operate on steep slopes.
Look for and keep away from hazards such as
drop-offs. Stay alert for holes, rocks and other hidden
hazards in the area of operation.
After hitting an object, disengage the PTO, turn off and
remove the ignition key and wait for all motion to stop.
Check for damage. Repair any damage before
restarting unit.
Look behind when operating in reverse. Look for
people and hazards.
Operate only from the operator’s position just behind
the handlebars.
If there is a sudden change in the sound or vibration of
the equipment, disengage the PTO, turn off and
remove the ignition key, wait for all motion to stop and
check for damage. Repair any damage or failure before
restarting unit.
Never run the engine indoors except to move it outside.
Exhaust fumes are dangerous.
Go slowly on slick surfaces. Always be sure of your
footing, keep a firm grip on the handlebars and walk,
never run.
Follow traffic laws when operating on or near a road.
Before leaving the operator’s position, put the PTO
lever in the “OFF” position, turn off and remove ignition
key. Move the shift control to first gear position.
Do not touch parts which might be hot from operation.
Before attempting to maintain, adjust or service allow
hot parts to cool.
Maintenance and Storage
Keep the equipment in good condition. Maintain it as
directed in this manual. Check all hardware at regular
intervals.
Use only Gravely accessories, attachments and
replacement parts.
Do not overspeed the engine. Do not override the
governor.
Before making any repairs or adjustments, disengage
the PTO, turn off and remove the ignition key and wait
for all motion to stop.
To reduce fire hazard and overheating, keep equipment
free of grass, leaves, debris or excessive lubricants.
Worn out mufflers can result in fire or explosion and
should be replaced immediately.
Never store equipment with gasoline in tank inside a
building where fumes may reach an open flame or
spark. Allow engine to cool before storing in any
enclosure.
Refer to
Storage
if unit is to be stored for extended
periods.
SPARK ARRESTER
This product is equipped with an internal combustion
engine. DO NOT use on or near any unimproved, forest
covered or brush covered land unless the exhaust
system is equipped with a spark arrester meeting
applicable local, state or federal laws. A spark arrester,
if used, must be maintained in effective working order
by the operator.