Filter
Top Products
14
REMOVING BAGGER KIT
1. Remove the hose from the blower assembly and
collector inlet (see figure 15 on page 13).
2. Remove belt cover.
3. Remove V-belt from double pulley (see figure 12 on
page 12).
4. Remove blower assembly (see figure 11 on
page 12).
5. Re-install belt cover.
6. Install discharge chute.
7. Remove counterweights (see figure 7 on page 11).
8. Remove grass container, mounting frame and
mounting legs (see figure 5 on page 10).
BEFORE EACH USE
1. Check bagger parts for wear, deterioration or
damage. Replace ONLY with Gravely original
service parts before operating.
2. Make sure counterweights are installed.
3. Make sure all hardware is tight.
IMPORTANT: Check tool-less hardware often. Tighten as
needed.
4. Remove any grass buildup from bagger parts.
5. Ensure hose is fastened securely on upper boot
and blower assembly.
BAGGING
Starting
1. Start engine and engage PTO according to unit
owner’s manual.
2. Set throttle to full.
3. Choose a slow ground speed.
Shut Off
1. Disengage PTO.
2. Shut off unit according to unit Owner/Operator’s
manual.
EMPTYING THE GRASS CONTAINER
If container stops picking up grass clippings, container
may be full.
To empty container:
1. Park the unit where you want to empty the
container.
2. Disengage PTO, stop engine and remove ignition
key. Wait for all moving parts to stop before leaving
operator’s position.
3. Pull the lift handle away from the grass container
and then lift upward. The container should pivot
backwards toward the ground and the door should
open, releasing container contents.
4. Clean out hose.
5. Pull the lift handle back and down to pivot the
container upright and to close the door.
6. Push the lift handle in towards the container to lock
the door latch in place.
IMPORTANT: Make sure the container door latches
securely.
UNCLOGGING GRASS CONTAINER
REMOVAL
CAUTION: Deflected material may cause injury.
ALWAYS operate mower with bagger cover
closed and secured, blower assembly fastened
securely, or with chute deflector in operating
position.
CAUTION: Always install counterweights on
front axle before operating unit with bagger
attached. Always remove counterweights from
front axle when bagger is removed from the unit.
OPERATION
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
WARNING: Lower attachment, stop engine, and
remove key to prevent unauthorized use. DO
NOT park on slopes.
WARNING: MOVING PARTS can cut or
amputate body parts.
NEVER attempt to clear blower assembly while
engine is running.
ALWAYS stop engine, remove key, and wait for
moving parts to stop.
Sharp edges can cut. Movement of parts can
cut off fingers or a hand. Wrap blade(s), wear
sturdy gloves and use extreme caution when
working near blades or impeller.