Filter
Top Products
13
5. Replace the belt cover removed in step 1. Keep the
discharge chute for operating the machine without
the blower attached.
NOTE: If you prefer tool-less belt removal, replace the
belt cover with the hardware provided in this kit. See
Figure 14.
INSTALL HOSE (FIGURE 15)
Connect the Discharge Hose
1. Trim the hose to the required length.
For 52-inch and 60-inch Decks, trim the hose so the
hose does not pull tight when the grass container is
in the dump position and the deck is set to its lowest
cutting height.
For 72-inch decks no trimming is required.
2. Connect the hose to the blower assembly and then
to the collector inlet. Secure the hose to the
collector inlet with the hose clamp.
3. Adjust the collector inlet angle to remove any sharp
bends or kinking.
4 Washers for
52-inch decks
2 Washers for 60-
& 72-inch decks
Figure 13
Figure 14
52-Inch Decks
60-Inch Decks
Rubber
Bumper
(Item 9)
Belt Cover
5/16" Wing
Knob
(Item 11)
Belt Cover
5/16" Wing
Knob
(Item 11)
72-Inch Decks
Belt Cover
5/16" Wing
Knob
(Item 11)
Rubber
Bumper
(Item 9)
CAUTION: Deflected material may cause injury.
ALWAYS operate mower with bagger cover
closed and secured, blower assembly fastened
securely, or with chute deflector in operating
position.
Item Description Item Description
2 Collector Inlet 4 Hose
3 Tool-Less Hose
Clamp
15 Blower Assembly
Figure 15
2
15
4
3