Filter
Top Products
12
Install Blower Assembly on Deck
1. Remove discharge chute and right belt cover from
the deck.
2. Install the drive belt on the blower assembly.
NOTE: The bagger kit includes three V-belts that have a
part number printed on each V-belt. Select the
appropriate belt for your deck:
• 52-inch mower deck V-belt (part number 07236200)
• 60-inch mower deck V-belt (part number
07213200).
• 72-inch mower deck V-belt (part number 07239700)
3. Install the blower assembly on the deck and secure
with the detent pin. Make sure the detent pin
passes through the bracket on the mower deck.
4. Connect the drive belt to the deck pulley.
NOTE: To increase belt tension add washers to the
compression spring. Decrease tension by removing
washers. Four washers for 52", two washers for 60" and
72" decks (figure 13).
Item Description Item Description
15 Blower Assembly 16 Finger Guard
6, 7 Front Baffle (not
needed on 72"
decks)
21 1/4-20 x 1/2 Hex
Bolt
20 1/4-20 Locking
Nut
26 3/8-16 x 1/2
Tapping Screw
47, 48 Rear Baffle
Figure 10
Ppt0090
6, 7
15
26
16
21
20
Blower Cover
and Hardware
47, 48
26
Item Description Item Description
13 V-Belt 15 Blower Assembly
Figure 11
Figure 12
ODd0234
15
13
Idler Disengage
Bend tab down
as needed to
obtain a snug fi
t
onto mower
deck assembly.
Detent
Pin
OTt3024
V-Belt
Blower
Assembly
Pulleys
Double
Pulley
Compression
Spring and
Washers