Filter
Top Products
Connecting a Liquid Propane Gas Cylinder to
your Patio Heater. (Must use LP gas only)
CAUTION: During and after each use, your patio
heater will be hot. NEVER touch your patio
heater or attempt to change the LP Gas Cylinder
until you are certain it is cool to the touch.
1. Turn gas Control Knob, located on front of
Patio Heater to the off position.
2. Remove the Cylinder Access Door. See Fig. 6.
Position the Cylinder (not included) under the
regulator. Support the Cylinder with one hand
and Connect the Cylinder head into the
Regulator Inlet as shown Fig. 7. With your
other hand turn the Cylinder from left to right
until the Cylinder is securely connected to the
Regulator Inlet.
4. Attach the Cylinder Access Door onto the
Patio Heater Base.
Figure 6
CYLINDER
ACCESS DOOR
Congratulations
Your Patio Heater is now ready for use.
Before the first use and at the beginning of
each season (and whenever the LP gas tank
has been changed):
1. Read all safety, lighting and operating
instructions.
2. Check gas valve orifices, burner tubes and
burner ports for any obstructions.
3. Perform gas leak check according to
instructions found on page 11 of this
Owner's Manual.
Figure 7
REGULATOR
CYLINDER
BASE
Disconnecting a Liquid Propane Gas Cylinder
from your Patio Heater
1. Turn gas Control Knob, located on front of
Patio Heater to the off position. Allow Patio
Heater to cool before removing Cylinder.
2. Remove the Cylinder Access Door.
.
Turn the Cylinder from right to left by hand,
until Cylinder is disconnected from the
Regulator Inlet, and remove from Patio Heater
Base.
4. Replace the Cylinder Access Door to the
Patio Heater Base.
t
CAUTION: When the patio heater is not in use,
the gas must be turned off at the supply tank.
Never store an LP Cylinder indoors.
10