Grand Hall 22899 Patio Heater User Manual


 
Checkall gas connectionswitha soapywater
solutionto be suretheyare tightand leak proof.
To makesoapsolution,mix onepartwaterwith
onepartliquiddetergent.
With the gas valve knob in the "OFF" position,
connect disposable propane cylinder to regulator
fitting by turning the cylinder left to right. Use a
soapy water solution to check all connections for
leaks before attempting to use your patio heater.
If bubbles appear in the soap solution the connec-
tions are not properly sealed. Check each fitting and
tighten or repair as necessary.
If you have a gas leak that cannot be repaired
by tightening, turn off the gas at the source,
disconnect fuel line from your patio heater and
call 1-888-317-7642 or your gas supplier for
repair assistance.
.
Push and HOLD the Control Knob in fully. Rotate
knob left and STOP about 1/4 inch before the IGN/
HIGH position. Hold Control Knob at this position
for 3 to 4 seconds allowing gas to travel up to the
burner. Then SLOWLY turn Control Knob left to
the" IGN / HIGH " position, until a click sound is
heard. You may have to repeat this step 3 or 4
times to light the burner.
.
Once the burner flame is lit, continue pressing
the Control Knob for 15 seconds to ensure
the burner remains lit. Then release the
Control Knob and adjust the heat to desired
level from "HIGH" to "LOW".
. If the burner does not stay lit, turn the
Control Knob to the "OFF" position, wait 5
minutes for gas to clear, then repeat the
lighting procedure again.
Note: At first use, the Patio Heater Reflector
may emit a slight odor and smoke due to the
burn-off of oils used in the manufacturing process
of this aluminum part. This is to be expected.
Familiarize yourself with the safety instructions
and warnings at the front of this Owner's Manual.
Do not smoke while lighting patio heater or check-
ing the gas supply connection.
Be sure your patio heater is placed in accordance
with the minimum clearance from combustibles as
described on page 3 of this Owner's Manual.
2. Be sure your LP Gas Cylinder is filled.
3. Check the cylinder connection for leaks by apply-
o o
ing a mixture of 50 Yowater and 50 Yoliquid
soap solution.
. The Control Knob must be in the full "OFF"
position.
z WARNING
A strong gas smell, or the hissing sound of
gas indicates a serious problem with your
Patio Heater or the LPG Cylinder. Failure to
immediately follow the steps listed below
could result in a fire or explosion which
could cause serious bodily injury, death, or
property damage.
Shut off gas supply to the Patio Heater.
Extinguish any open flame.
Get away from the LPG Cylinder.
Do not try to fix the problem yourself.
If odor continues or you have a fire you
cannot extinquish, call your fire department.
Do not call near the LPG Cylinder, be
cause your telephone is an electrical
device and could create a spark resulting
in fire and/or explosion.
1. Turn gas Control Knob to the off position. Allow
unit to cool before removing 1 pound LP Cylinder.
2. Open the rear mounted Cylinder Access Door and
turn the cylinder by hand right to left until discon-
nected from regulator inlet.
3. NEVER store an LP Cylinder indoors.
4. Replace the rear mounted Cylinder Access Door.
11