Filter
Top Products
ASSEMBLYANSTALLATION
SET-UP
1.
Remove the two hood bolts, flats and locks, from
the center bottom of each side of the hood. Pivot
the hood open.
2.
Position the handle into the end of the chassis
closest to the wheels. Line up the four mounting
outside of the chassis. Use flat washers only on
holes. Install the four 3/8
x
1
inch bolts from the
head of bolt. Use
a
flat washer, lock washer, and
nut on each bolt on the inside of the chassis.
3. Connect one end of the 30 foot high pressure
with
a threaded swivel fitting. Connect the other
hose to the pump outlet. This connection is made
end to the gun using the quick couplers provided.
CAUTION
Using longer hoses may affect sprayer
performance, and chemical injector
performance.
4
mzn6
and install the dipstick.
4.
Remove the plastic plug from the top of the pump
NOTE:
The plastic plug may he reused to
transporting the pressure washer
in
a
prevent splashing oil when
vehicle. Be sure to reinstall the
dipstick before using the unit to allow
proper venting.
5.
Hood may now be closed and secured with hood
bolts, flat washers, and lock washers removed
in
Step
1.
6.
Remove the plastic plug from the inlet hose.
Check the water supply flow rate (see page
5).
Connect inlet hose to water supply.
A
standard
5/8
I.D. garden hose may be used to connect inlet
hose to the water supply.
-~
..
.
..