Filter
Top Products
WARNING
HIGH
PRESSURE SPRAY
CAN
CAUSE
SERIOUS INJURY.
FOR PROFESSIONAL
USE
ONLY. OBSERVE ALL WARNINGS.
Read and understand all instruction manuals before operating equipment.
FLUID
INJECTION
HAZARD
This 'pressure washer generates very high fluid
General Safety
pressure. Spray from the gun, leaks or ruptured
components can inject fluid through your skin and
injury, including the need for amputation. Also, fluid
into your body and cause extremely serious bodily
injected or splashed into the eyes or on the skin can
cause serious damage.
In
addition, some cleaning
solutions maybetoxicandcancausechemical burns,
skin irritations, and allergic reactions if inhaled or if
follow
these precautions when operating your
they come
in
contact with the body or eyes. Always
pressure washing system to reduce the risk
of
serious bodily injury.
NEVERpointthespraygunatanyoneoratanypartof
wand. NEVER put hand or fingers over the spray
tip.
the body. NEVER use the spray gun without the
NEVER try to stop or deflect leaks with your hand or
body.
.
ALWAYS be sure equipment safety devices are
operating properly before each use.
diluted cleaning solutions. NEVER use the pump for
Use this pump only for pumping water and water-
paint or.any other coatings.
ALWAYS wear protective eyewear and appropriate
clothing to protect yourself from the overspray and
the debris that is removed as you clean.
Read and follow the cleaning chemical
manufacturer's recommendations on preparation
breathing apparatus and proper ventilation.
and use of the cleaning solution, and the use
of
MEDICAL
TREATMENT
If any fluid appears to penetrate your skin, get
EMERGENCY MEDICAL
CARE AT
ONCE.
DO
exactly what fluid was injected.
NOT
TREAT
AS
A
SIMPLE
CUT.
Tell the doctor
Note
To
Physician: Injection
in
the
skin
is a
traumatic injury.'
It
is important to treat the
injury surgically as soon
as
possible.
Do
not
delay treatment to research toxicity. Toxicity
isa
concern with some exotic coatings injected
directly
into
thebloodstream. Consultation with
a plastic surgeon
.
or
reconstructive hand
surgeon may be advisable.
To reduce the risk of serious bodily injury, including
Pressure Relief Procedure
fluid injection and splashing
in
the eyes, or on the
skin, always follow this procedure whenever you
shut
off
the pump, when checking or servicing any
part of the system. when installing or changing spray
tips, and whenever you stop spraying for more than
10
minutes.
1.
Engage the gun trigger safety latch.
3.
Remove the power cord from outlet.
2.
Turn pressure washer OFF.
4.
Shut
off
the water supply.
5.
Disengage the trigger safety latch andtriggerthe
gun to relieve pressure, and engage the latch
again.
Spray
Gun
Safety
Do not remove or modify any pait of the gun; this can
cause a malfunction and result in serious bodily
injury.
Safety Latch
ALWAYS engage
the
gun safetylatch whenever you
stopcleaning,evenforamoment.ThelatchMUSTBE
pushed fully down
to
make the gun inoperative.
Failure to properly set the safety latch can result in
accidental triggering of the gun. See Figure
2.
page
6.
Spray
Tip
Safety
Use extreme caution when cleaning
or
changing
spray tips. If the spray tip clogs while spraying,
engage the gun safety latch immediately. ALWAYS
follow the Pressure Relief Procedure and then
remove the spray tip
to
clean
it.
2
802-776