Filter
Top Products
HIGH
PRESSURE SPRAY
CAN
CAUSE
SERIOUS
INJURY.
FOR
PROFESSIONAL
USE
ONLY.
OBSERVE
ALL WARNINGS.
Read and understand all instruction manuals before operating equipment.
IN
JECTlON
penetrate
the
skin and cause extremely serious injury,
fluids under high pressure from spray or leaks can
including the need for amputation.
NNER
point the spray gun
at
anyone or any part of the
body.
NNER
put hand or fingers over the spray tip.
NNER
try
to
stop or deflect leaks with your hand or
body.
ALWAYS
have the tip guard in place when spraying.
MEDICAL TREATMENT&~;T:",'?
''<?.X
If
any fluid appears to penetrate your skin, get
EMERGENCY
MEDICAL
CARE
AT ONCE.
Tell the doctor exactlv what fluld
was
miected. For
BO
NOT TREAT AS A S!MPLE CUT.
treatment instructions have your doctor
Cali
the
NATIONAL POISON CENTER NETWORK
(412)681-6669
AVOID COMPONENT
RUPTURE"~~,-:r_',":;i.'.
pressure in the pump, hose and gun until
you
relieve
it
Even after you shut
off
the electric motor, there is high
by triggering the gun.
So
before removing the spray tip
the gun to release pressure.
or servicing the unit, ahys shut
off
the unit and trigger
ponents will withstand the pressure developed.
NNER
Be sure that
all
accessory items and system com-
.exceed the pressure rating of any component in system.
NNER
alter or modify equipment-your personal
safety, as well as the function of the equipment,
is
at
stake.
Before each
use,
check hose for weak, worn
or
damag-
ed conditions caused by traffic, sharp corners, pinching
or kinking. Tighten
all
fluid connections securely before
each
use.
Replace any damaged hose.
ble with Buna-N and PVC or neoprene cover of hose.
Do
not
use
chemicals or agents which are not compati-
unit and relieve pressure before leaving.
Do
not leave
a
pressurized unit unattended. Shut
off
the
FIRE
:..
.~
,
.. .
,
.
,,,:
,
>,
...
i
~~.<,.,
i.-:
*.'.
.,-.'i
,
,*.,.
.,.._
,,..
,,,*+
_c.
Do
not spray flammable liquids.
Do
not operate the unit
where combustible fumes or dust may be present.
GENERAL
' '
.
,,
.:,
:k;k'
,,.!$.,,>~.
:.
.:
NNER
run the unit with the belt guard removed. Keep
clear of moving parts when
the
unit is running.
Observe detergent manufacturer's safety precautions.
Avoid getting detergent or other liquids in your eyes.
Follow the directions on the container regarding contact
with eyes, nose, and skin, breathing fumes, etc. Always
wear full goggles to protect your eyes from the spray as
well
as
any debris dislodged by the spray. If necessary,
wear gloves or other protective clothing. If antidotes or
treatment are recommended, be prepared
to
use them.
weed killer.
DON'T
spray toxic chemicals such
as
insecticide or
This unit has
a
3-prong grounding plug to protect you
from electric shock.
Be
sure to plug the unit into
a
pro-
Do
not remove
the
third
prong.
perly grounded outlet that will accept the 3-prong plug.
The green
wire
of the electric cord
is
connected to the
unit chassis and motor frame and the other
two
wires
are connected to the motor switch for grounding
continuity.
The electric motor has an overload protection device
which automatically shuts
off
the motor if
it
overheats.
So,
before examining or working on
a
motor which has
stopped, shut
off
the unit, relieve pressure and pull out
the electrical plug. This will avoid the hazard of the
motor starting unexpectedly.
ALWAYS CHECK to be sure the switch
is
OFF
and that
the hoses and electric cord are clear
of
moving parts
before plugging in the power cord.
~. ~. . .
,..
,
.
.",.
;~..._il_x_~**"~.
. . .
-
,
.
.,
..
,,..,I
,
..
,
. .
1.
~~ . .
>
..
,
IMPORTANT
United States Government safety standards have been adopted under the Occupational Safety and Health
Act.
These
consulted in connection with your
use
of airless spray equipment.
standards
-
particularly the General Standards, Part
1910,
and the Construction Standards, Part 1926
-
should be
."
2,
801-238