Filter
Top Products
2 Genie DPL Super Series Part No. 82799
Operator’s Manual Second Edition • First Printing
Tip-over Hazards
Do not raise the platform
unless the base is level,
all four outriggers are
properly set up and the
leveling jacks firmly
contact the ground.
Do not move the machine
while the platform is
raised.
Do not adjust or remove the outriggers while the
platform is occupied or raised.
Do not place or attach overhanging loads to any
part of this machine.
Do not transport tools and materials unless they are
evenly distributed and can be safely handled by
person(s) in the platform.
Do not raise the platform
unless the machine is
level. Do not set the
machine up on a surface
where it cannot be leveled
using only the outriggers.
Do not place ladders or
scaffolds in the platform or
against any part of this
machine.
Do not push off or pull toward any object outside
the platform.
Maximum allowable
manual force 90 lbs 400 N
Do not use the machine on a moving or mobile
surface or vehicle.
Do not operate the machine in strong or gusty
winds. Do not increase the surface area of the
platform or the load. Increasing the area exposed to
the wind will decrease machine stability.
Occupants, equipment and materials shall not
exceed the maximum platform capacity.
Maximum capacity - DPL-25S
ANSI and CE 750 lbs 340 kg
CSA 600 lbs 272 kg
Maximum occupants 2
Maximum capacity - DPL-30S
ANSI and CE 750 lbs 340 kg
CSA 600 lbs 272 kg
Maximum occupants 2
SAFETY RULES