Filter
Top Products
CIMPLICITY PMCS Read-This-Book-First Installing the Software •
••
• 15
• CIMPLICITY HMI for Windows NT (Intel) Version 4.01 with HMI Service
Pack 9 or CIMPLICITY HMI for Windows NT (Intel) Version 5.00 with HMI
Service Pack 1is required. Other versions of CIMPLICITY may not be
compatible with PMCS.
If you are installing CIMPLICITY HMI, follow the directions provided with the
software (inside the CD jewel case). Choose CIMPLICITY HMI as the product to
install, then select either the HMI Server or Viewer as the product option to install,
and C:\CIMPLICITY\HMI as the installation directory. If you install the Server
option, also install Server Option - Communications - Advanced DDE/DDE
Client.
Installing Additional Software
Install any additional software, such as Microsoft Excel, at this point in the
procedure. Follow the instruction procedures provided by the manufacturer.
For instructions on installing SISCO Systems' MMS Server for use with PMCS, refer
to the section titled Using MMS Servers with PMCS.
RS485 PMCS Network Interfaces
If you are using an RS485 interface card to connect to the PMCS network, install the
card following the manufacturer’s installation instructions. Be sure to install any
Windows NT drivers provided by the interface-card vendor. Typically, drivers are
installed at Control Panel>Network>Adapters>Add Adapter by following the
instructions. You may be prompted to insert the manufacturer’s disk into the A:
drive.
From the Network
control panel, select
the Adapters tab,
then click Add.