Filter
Top Products
8
3.2 INSTALL THE HOOD ASSEMBLY AND BAGS
Lazer Z units only (Lazer Z XP units skip to step 3.2.7)
3.2.1 When installing the Ultra Vac onto a liquid cooled Lazer Z, the rear bumper plate
must be removed. Remove rear bumper plate. Reattach the lower side bumper
bars to the vertical “HOT” engine guard shield using two of the original screws,
washers and whizlock nuts removed from the bumper plate.
3.2.2 Remove the lower two screws holding the clutch guard plate (“HOT” engine guard
on liquid cooled units) to the rear frame of the Lazer Z unit. Units with serial
numbers 149,999 and below will require disassembly of the clutch strap spacers to
remove these screws.
3.2.3 On units with serial numbers above 190,000 install the mount weldment (Item 9)
loosely to the rear of the machine using the two bolts and nuts removed in section
3.2.2.
For units with serial numbers 189,999 and below, install washers (Item 31)
between the bagger mount weldment and clutch guard when installing the bagger
mount weldment. This will provide for proper alignment of the mount holes with
the holes in the bagger assembly (See figure 1).
For units with serial numbers 149,999 and below, remove the two tap bolts that tie
the clutch straps to the clutch guard and replace with new tap bolts (Item 32).
These units also require the use of the washers (Item 31) between the bagger
mount weldment and the clutch guard. These parts should be installed when the
bagger mount weldment is installed on the rear of the unit (See figure 1).
3.2.4 Jack the rear of the unit up and safely support it on jack stands. Remove the rear
wheels.
CAUTION
POTENTIAL HAZARD
♦ Relying solely on mechanical or hydraulic jacks to
support the mower could be dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic jacks may not be enough
support or may malfunction allowing the unit to fall,
which could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or hydraulic jacks
for support. Use adequate jack stands or equivalent
support.
FIGURE 1
FOR SN 149,999 ONLY
(Item 31 also used for SN 150,000-189,999)